RJXHOBBY Launching Pad For Mini Drone Eachine E010 E010C E010S JJRC H36 Tiny6 Tiny7 GoolRC T36 Blade Inductrix Tiny Whoop AND Kingkong Orange
Size: 48mm - 85mm
Racing style launching pad for Tiny Whoop, Blade Inductrix / clones and Kingkong Tiny 7 brushed quadcopters.
Launching your quad in a canted forward position allows starting at a higher speed, eliminating the need of climbing before gaining forward speed.
Ball joint design allows pivoting up to approx. 20 degrees in any direction.
Thin arms prevents unintentional lifting your quad by ground effect, especially from idle speed / air mode.
Dimple shaped recesses provide just enough retention without "sinking" too deep into the launching pad.
Launching in extreme angle can be problematic if your quad is in Angle / Horizon / auto-leveling modes, launching in Acro / Rate Mode is recommended, or just do the whole race in Acro, it's challenging and FUN!
Test ability to arm before flight! Default small_angle value in BetaFlight allows arming if your quad is canted up to 30 degrees, decrease cant angle or increase small_angle value if you have trouble with arming your quad.
Print upper part upside down for easier print.
Feel free to report in comment section if you encounter any issues with the design.
1 x Launching Pad Orange
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: